S&W Model 10 cylinder spring

Find solutions to your pistol problems or discuss ways to customize or enhance your pistol.

S&W Model 10 cylinder spring

Postby casper_zip » Tue Dec 22, 2009 9:45 am

Hey there:

My model 10 will eject the spent cases, but will not auto return to closed position. I have to push it back by hand. O.K. how do I fix this ? I have a new spring ordered to replace.

Looking down into where the spring is; I can see a spring, or it looks like one. Will I have to use a male threaded die and see if I can extract it ? I'm sure it must and will have to come out. Looks like someone put in a spring that was not the right one, and it is stuck.

Please help me if you will/can, and I thank you.

casper_zip
casper_zip
.22 cal
 
Posts: 1
Joined: Wed Dec 16, 2009 4:32 pm

Re: S&W Model 10 cylinder spring

Postby Road Rat » Tue Dec 22, 2009 11:04 am

Casper, the best I can do is point you to a manual with great drawings.

Maybe it will help!

http://stevespages.com/pdf/s&w_10.pdf
Keep Them In The TEN Ring.
User avatar
Road Rat
.38 cal
 
Posts: 231
Joined: Thu Jul 16, 2009 10:42 am
Location: Iowa


Return to Gunsmithing & Restoration

Who is online

Users browsing this forum: No registered users and 2 guests