Lead in my barrel!

7685 Views 11 Replies 8 Participants Last post by RMc, Jun 12, 2006

huntswithdogs

Discussion Starter · May 23, 2006

I loaded some 250 semi-wadcutter bullets recently in front of charge of Clays and shot all 100 in one afternoon. I didn't look down my barrel til I got home and have been trying to get this mess out every since. I've been running a wet patch down the barrel and letting it soak for awhile then running a brush thru it multiple times. THIS CRAP WON"T COME OUT!!!!!!!!!!!!!!

If I were to load up a couple of rather warm JHP bullets and shoot them,would this blow this mess out of my barrel.

After all this I went back a took a close look at these bullets. They seem rather soft.I should probably pull the ones I have loaded now and not shoot them.

Any comments or suggestions? I've not tried a Toronado brush yet but am headed to the gun store tomorrow.

HWD

Save

1 - 1 of 12 Posts

wwb

· #2 · May 23, 2006

A barrel plug, some lead solvent, and some patience.... plug it, stand it on end, fill it up, and wait.

Moral of the story..... HARDcast bullets and gaschecks.

Don't feel bad.... I learned it the hard way, too.

Save

1 - 1 of 12 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.