Pistol World Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
hey all,cant get anybody at Ruger-lines busy,so I will try here.
I have had a Bisley vacquero close to 10yrs now,maybe shot less than 500 rnds thru it the whole time.
Always noticed the bolt falling upon the cylinder way before
the leade for the stop notches.early bolt release timing I think.
contacting about halfway between both notch cutouts.
Is this normal for a Ruger?,or should it be dropping on the
leade like a colt saa?
thanks!
B
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top